Flywheel - generator
Tighten screws to the specified torque (Sect. C 3,
Refitting flywheel / generator assembly
Fit washer (17), roller bearing (19) and inner ring (18) on crankshaft. Make sure that inner ring becomes seated
properly in the centre of the washer.
Fit starter driven gear (20) on flywheel starter clutch.
Fit the thus-assembled flywheel unit (22) on the starter clutch (21). Make sure the inner ring (18) is still centered in
the washer (17).
Flywheel reference mark must be aligned with the crankshaft spline near the keyway.
Lubricate mating surfaces of Belleville washer (33) with engine oil.
Fit Belleville washer (33) onto crankshaft end.
Caution
Belleville washer (33) larger side shall be facing the flywheel.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_8_9_00.72.1.html (9 of 14) [10/7/2008 8:46:19 PM]
Engine torque
settings).