Ducati Monster 695 User Manual page 517

Casing unit: crankcases
Reassembling the generator-side casing
Check that the following parts are in place inside casing:
The double ball ring bearing (10) for the selector fork shaft with plate (9) and retaining screws (8).
The gearbox primary shaft bearing (12) with inner spacer (13).
Main bearing (4).
The ball bearing (7) with circlip (6) at the position of the timing layshaft.
Note
Except for the main bearings, all other bearings do not have a mounting position.
Shimming the shafts
Before closing the casings, calculate the shims required to take up crankshaft and gearbox shafts end float.
To determine correct shimming, proceed as follows.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (9 of 25) [10/7/2008 8:46:34 PM]