Table of Contents
Advertisement
Clutch unit: APTC wet clutch
Caution
Overall thickness of the set of clutch plates should not be less than 50,2 mm.
Place the plate on a flat surface and check the amount of deformation with a feeler gauge.
Max flatness error: 0.2 mm.
Overhauling the pressure plate
Check bearing (6) condition. Change bearing if you find too much play.
Check contact surface of last driven plate. If extremely scored, apply a lapping compound (6-12 micron thick) onto a
working surface and move the plate until it is perfectly flat.
Check the condition of the spring guides (A) of the pressure plate (5). Change the spring caps (2) at every overhaul.
Overhauling the pressure plate springs
Measure the length "L" of the uncompressed springs (4):
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_6A9_00.67.1.html (7 of 12) [10/7/2008 8:45:55 PM]
Hide quick links:
Advertisement
Table of Contents
