Stands
Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear
in the figures near the text.
Removing the side stand
Disconnect the connector (A) of the side stand switch (5) from the main wiring harness.
Undo the two screws (2) that secure stand plate (3) to engine. Remove the complete side stand.
Disassembling the side stand
Unscrew the retaining screw (4) and remove the stand switch (5).
Unhook the stand return springs (6) from the pin located on the stand plate (3) and remove the springs.
Unscrew the pivot (8) retaining the stand to the plate and remove the side stand (1) and the nut (9).
Inspecting the side stand
Fit the stand to the plate and check for exceeding play. Ensure that the ends of the stand are not bent with respect to
the shank. A stand which shows signs of cracking must be replaced immediately.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_H_5_7_00.44.1.html (2 of 3) [10/7/2008 8:44:21 PM]