Table of Contents
Advertisement
Casing unit: crankcases
Match the casings (3) and (16). Tap the area around the shafts with a plastic hammer, if necessary.
Start the jointing screws into their holes on the generator-side casing (3). The screws are not all the same length, be
sure to position them correctly.
Note
Apply recommended grease when refitting drilled screw (28).
Ref.
Qty.
Description
25
6
M8x75 mm
screws
28
1
M8x75 mm
drilled screw
26
5
M6x35 mm
screws
27
1
M6x75 mm screw
Progressively tighten the jointing screws all the way in. Begin with the larger diameter (M8) screws.
Fit two M8 screws (29) to clutch-side casing (16).
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (24 of 25) [10/7/2008 8:46:35 PM]
Hide quick links:
Advertisement
Table of Contents
