Electric starting
3 - Electric starting
Note
Items reference numbers refer to
Electric starting system
The key components of the electric starting system are a starter contactor (7) and a starter motor (6)
fed by the battery (8).
ECU (28) has total control on motorcycle ignition procedure. It monitors the following inputs:
- Engine Stop on right switch (1)
- Engine Start on right switch (1)
- Neutral sensor (30)
- Side stand sensor (27)
- Clutch microswitch (43)
If all above inputs send enabling signals, the control unit (28) will enable engine ignition procedure.
The table shows possible ignition combinations.
If all inputs are in OK status, the control unit will enable the starter motor (ON) when START is pressed.
X = generic status of neutral, clutch and stand.
Safety devices function table
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_P_3_9_00.80.1.html (1 of 6) [10/7/2008 8:47:02 PM]
"Wiring
diagram" in Section P 1.