Rear suspensions
Reassembling the rear suspension rocker arm
Fit two new roller bearings (3) onto the drift part no. 88713.1071
Support the rocker arm and drive the needle roller bearings fully home into the rocker arm.
Caution
Fit the bearings squarely in the hole: use a press in case of jams.
Fit a new seal (2) on the drift as shown in the cross-section view. Drive it onto the needle roller bearing previously
fitted.
Repeat the above procedure for the other needle roller bearings and the other seal.
Lubricate bearings and oil seals with recommended grease and insert the inner spacer (8).
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_G_7_8_00.38.1.html (6 of 8) [10/7/2008 8:44:04 PM]