Thread - Ducati Monster 695 User Manual

Flywheel - generator
Lock out flywheel rotation using the relevant tool part no. 88713.2036.
Remove any Loctite residue from nut (34) and crankshaft (A) thread.
In order to ensure correct coupling, sealant should be applied in 3 stripes along the crankshaft thread (A) and one
stripe inside the nut (34).
Fit nut (34) onto shaft end (A): nut (34) larger side shall be facing the flywheel.
Caution
Nut (34) is to be tightened immediately after sealant is applied;
tighten to the specified torque (Sect. C 3,
Warning
It is also recommended to allow three hours after tightening before starting the engine to ensure the sealant is
completely dry.
Reassembling generator cover
Position stator (32) into the cover with the hole for the outgoing wire facing the cover and pointing towards the cover
recess.
Apply threadlocker to the retaining screws (24) of the stator and tighten the screws to the specified torque (Sect. C3,
Engine torque settings).
Place the guide plate (30) over the wire and secure it to cover with the two screws (31).
Before installation, make sure that the crankshaft bearing (26) and its circlip are in place in the generator cover (28).
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_8_9_00.72.1.html (10 of 14) [10/7/2008 8:46:19 PM]
Engine torque settings).