Ducati Monster 695 User Manual page 237

Footpeg supports
19 Screw
20 Complete LH footpeg
21 Spacer
Spare parts catalogue
Gearchange lever - foot rest
Caution
Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear
in the figures near the text.
Removing the footpegs
The removal procedure described below applies to both RH and LH footpegs.
To remove the right footpeg, unscrew the two screws (B) and remove the rear brake master cylinder (A). Leave the
master cylinder connected to the system.
Before removing the left footpeg plate, loosen the screw (D) securing the gearchange control (C) to the engine and
leave the gearbox unit connected to the plate.
Unscrew the two upper screws (13) securing the plate to the frame.
Note
Between the right footpeg support and the frame is the canister support bracket (for USA version only).
Collect the washers (2) placed between plate and frame.
Loosen the screw (E) securing the silencer to the footpeg, collect the nuts and the washers.
Unscrew the lower retaining screws (3) on the engine casing.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_H_4_7_00.43.1.html (2 of 5) [10/7/2008 8:44:18 PM]