Gearbox assembly: gearbox shafts
To remove them from the shaft ends use puller part no. 88713.1332 and then fit them in their relevant bearings on
the casings.
Disassembling the gearbox shafts
Put the shaft in a vice to make disassembly operations easier.
Caution
Refit the shims in the original positions on assembly.
Failure to do so could lead to jamming and you will have to re-open engine casing.
Disassembling the secondary shaft
Remove the clutch-side shim (26) and the chain-side shim (15) from secondary shaft.
Slide out the first driven gear (18) with needle roller bearing (17) and shim (19).
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_7B9_00.71.1.html (4 of 17) [10/7/2008 8:46:12 PM]