Exhaust system
Install the four vibration damping pads (9) – if they have been removed, on both sides of the footpeg plate (A).
Fit the bushes (20) into the silencer brackets (19) and (13).
Rest the silencer brackets against footpeg plates (A) and insert the bushes (10) fully home.
Insert the screws (11). Fit the washers (14) at the opposite end and snug the nuts (15) finger-tight.
Hold nuts and tighten the screws (11) to the specified torque (Sect. C 3,
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_L8_10_00.52.1.html (7 of 9) [10/7/2008 8:44:55 PM]
Frame torque
settings).