Table of Contents
Advertisement
Casing unit: crankcases
Caution
After installing new main bearings, shim the crankshaft as described under paragraphs
"Closing the
casings" in this Section.
Reassembling the casings
Carefully inspect the casings. They should be in perfect conditions and clean. Mating surfaces must be perfectly flat
and free from burrs.
Reassembling the clutch-side casing
Check that the following parts are in place inside casing:
Secondary shaft end bearing (15).
Primary shaft bearing (14) secured with screws (18) and spacers (17).
Main bearing (23).
Roller bearing (21) with circlip (22) at the position of the timing layshaft.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (8 of 25) [10/7/2008 8:46:34 PM]
"Shimming the
shafts" and
Hide quick links:
Advertisement
Table of Contents
