Table of Contents
Advertisement
Seat
Refitting the splash guard
Insert the splashguard (16) from the rear end of the motorcycle.
Fit the screw (7) with washer (12) to the oil breather tank front hole (A).
Position the washer (5) and tighten the nut (13) on the screw (7).
Start the screws (3) with their washers (4) in their holes and tighten the screws (3) to the specified torque (Set. C 3,
Frame torque
settings).
Refit the seat as described under
Removing the side body panels
Remove the seat as described under
Loosen the four screws (9) securing the side body panels (11) to the frame, keep the washers (10) and inserts (14).
Remove the right-hand and left-hand side body panels (11).
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_E_3_4_00.22.1.html (5 of 7) [10/7/2008 8:43:13 PM]
Refitting the seat
in this section.
"Removing the
seat" in this section.
Hide quick links:
Advertisement
Table of Contents
