Turning On The Power - GRAPHTEC FC8000 SERIES User Manual

2 -
5

Turning on the Power

Turning on the power of the plotter.
Operation
1
Check that the power switch is turned off (the "u" side is
pressed down).
2
Connect one end of the provided power cord to the FC8000 AC
line inlet and the other end to an electrical socket of the rated
supply voltage. Make sure that the FC8000 is grounded using
the 2/3 prong adapter for the outlet that is not 2 pin socket.
3
Turn on the FC8000 by pressing the "|" side of the switch. The
control panel POWER lamp lights.
4
If media has not been loaded, the firmware version number is
displayed, followed by a prompt to load media.
Media set lever raised Media set lever lowered
2-16
Supplement
This screen is described as "default screen" in
l
this document.
Settings such as initial media feed speed and
l
communication conditions can be performed.