Exec-Timeout; History - Allied Telesis AT-8000S Cli Reference Manual

Allied Telesyn AT-8000S Switch
CLI Reference Guide

exec-timeout

The exec-timeout Line Configuration mode command sets the interval that the system waits until user input is
detected. To return to the default configuration, use the no form of this command.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
Parameters
•
minutes — Specifies the number of minutes. (Range: 0 - 65535)
•
seconds — Specifies additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.
Examples
The following example configures the interval that the system waits until user input is detected to 20 minutes.
Console(config)# line console
Console(config-line)# exec-timeout 20

history

The history Line Configuration mode command enables the command history function. To disable the command
history function, use the no form of this command.
Syntax
history
no history
Default Configuration
The command history function is enabled.
Command Mode
Line Configuration mode
User Guidelines
This command enables the command history function for a specified line. To enable or disable the command
history function for the current terminal session, use the terminal history user EXEC mode command.
Page 108