Dtc P0223: Throttle Position Sensor (Sub) Circuit High - Suzuki GRAND VITARA Owner's Manual

DTC P0223: Throttle Position Sensor (Sub) Circuit High

Wiring Diagram
Refer to "DTC P0222: Throttle Position Sensor (Sub) Circuit Low: ".
DTC Detecting Condition and Trouble Area
Output voltage of throttle position sensor (sub) is more than specified value
for specified time continuously.
(1 driving detection logic)
NOTE
When DTC P0123 and P0223 are indicated together, it is possible that "WHT" wire shorted to power
circuit and/or "GRN" wire open.
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Keep the accelerator pedal at idle position for 2 seconds.
4) Keep the accelerator pedal at fully depressed position for 2 seconds.
5) Repeat Step 3) and 4) for 3 times.
6) Check DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions For DTC Troubleshooting: ".
Step
1 Was "Engine and Emission Control System Check"
performed?
2 Throttle position sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch, check "TP Sensor 2 Volt"
displayed on scan tool when accelerator pedal is idle
position and fully depressed.
Is displayed TP sensor value as described voltage in "Scan
Tool Data: "?
DTC detecting condition
Action
Engine General Information and Diagnosis:
• Throttle position sensor (sub) circuit
• Electric throttle body assembly
• ECM
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection: in Section
00".
1A-118
S5JB0A1104076
Trouble area
No
Go to "Engine and
Emission Control
System Check: ".
Go to Step 3.