Dtc P0108: Manifold Absolute Pressure Circuit High Input - Suzuki GRAND VITARA Owner's Manual

Grand vitara
Hide thumbs Also See for GRAND VITARA:
Table of Contents

Advertisement

Step
6
MAP sensor signal circuit check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Measure resistance between "C37-55" terminal of ECM
connector and vehicle body ground.
Is resistance infinity?
7
MAP sensor output signal check
1) Check MAP sensor according to "Manifold Absolute
Pressure (MAP) Sensor Inspection: in Section 1C".
Is it in good condition?

DTC P0108: Manifold Absolute Pressure Circuit High Input

Wiring Diagram
Refer to "DTC P0106: Manifold Absolute Pressure Range / Performance: ".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Manifold absolute pressure sensor output voltage is higher
than specified value for specified time continuously.
(1 driving cycle detection logic)
NOTE
When DTC P0113, P0118 and P0533 are indicated together, it is possible that "GRY/GRN" wire circuit is
open.
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch turned OFF.
2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.
3) Run engine at idle speed for 1 min.
4) Check DTC and pending DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions For DTC Troubleshooting: ".
Step
1
Was "Engine and Emission Control System Check"
performed?
2
MAP sensor and its circuit check
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ignition switch ON.
3) Check intake manifold pressure displayed on scan tool.
Is it 127 kPa (37.5 in.Hg)?
Action
Action
Engine General Information and Diagnosis:
Yes
Go to Step 7.
Substitute a known-
good ECM and recheck.
Trouble area
• Manifold absolute pressure sensor circuit
• Manifold absolute pressure sensor
• ECM
Yes
Go to Step 2.
Go to Step 3.
1A-82
No
"RED/WHT" wire is
shorted to ground
circuit.
Faulty MAP sensor.
S5JB0A1104022
No
Go to "Engine and
Emission Control
System Check: ".
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection: in Section
00".

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents