Battery level
Checking battery level
If the battery icon is changed to [電池マーク%表示], battery level is
displayed in percentage. However, [&] appears when battery level is
100% while [(] appears when battery level is 4% or less.
The battery icon and Percentage are rough indications.
The battery level may change a lot depending on the conditions of use.
If the FOMA terminal is left for a long period or without turning off the power,
the battery level may decrease even after the charging is completed.
"
0
!
#
$
%
Changing design of battery icon
■
1
In the Custom menu, select
[Battery icon]/i.
2
Select an image/i.
Displaying battery icon in percentage temporarily
■
<Icon% temp display>
When the design of the battery icon is set to other than [電池マーク%表示],
if the display is shown again with the display off, the battery icon in
percentage is displayed for approximately 3 seconds.
1
In the Custom menu, select
[Icon% temp display]/[ON].
54
Battery is sufficiently
81 to 100%
remaining.
61 to 80%
Battery is remaining.
41 to 60%
Battery level is low.
21 to 40%
Battery level is very low.
Battery is almost empty.
1 to 20%
Charge the battery.
Battery is empty (Power will
0%
turn off soon).
<Battery icon>
[Settings]/[Battery]/
[Settings]/[Battery]/
Checking battery level with sound and display
1
In the Custom menu, select
[Battery level].
: Battery level is displayed in percentage and graphic. In addition, it is
notified by the number of the battery level sound according to its
remaining amount.
Graphic
: Wait approximately 5 seconds and the display disappears.
: The battery level sound is heard at the volume set in Key/Touch
sound (nP. 98).
: If the Manner mode is set, the battery level sound follows the setting
of the Manner mode.
If battery runs out
[Battery empty. Unsaved data will be lost. Ending current
operation] appears if battery starts to run out (Press t to
clear the message). After a while, an alert tone sounds.
The warning screen stating that the battery runs out
appears, handset operations are disabled and power turns off after
approximately 60 seconds.
During a voice/Videophone call, the alert tone sounds and [Battery
empty. Unsaved data will be lost. Ending current operation] appears. The
call is disconnected after approximately 20 seconds. At the same time,
the screen above appears and after approximately 60 seconds, the
power turns off.
[Settings]/[Battery]/
Number of beep sound
Five times
Four times
Three times
Twice
Once
Need help?
Do you have a question about the Prime SH-06A and is the answer not in the manual?
Questions and answers