Docomo Prime SH-06A Instruction Manual page 223

[Switch img/voice]/select the setting/t
Set the image and voice combination.
[File size limit]/select the file size/t
[Camera settings]
/[Noise reduction]/select the setting/t
Set whether to minimize audio noise.
/[Display light time]/select the setting/t
Set backlight illumination time while shooting.
[Common replay mode]/select the setting/t
Set whether to replay moving pictures on other FOMA terminals.
[File size limit]
When sending with i-motion mail, select [For mail (short)] or [For mail
(long)]. Record based on the allowable size of mail attachment. Select
[For mail (short)] to limit the file size to up to approximately 500 KB.
Select [For mail (long)] to limit the file size to up to approximately 2 MB.
If File size limit is set to [Unrestricted], the maximum recorded size is
approximately 5 MB when the save destination is set to the FOMA terminal
handset, and the maximum recorded size is unrestricted when the save
destination is set to the microSD Card. The maximum recording time is
approximately 1 hour (except when Switch image/voice is set to [Voice only]).
When mail is sent right after shooting, the first 2 MB or less are cut and sent.
File size changes depending on image size.
When the Common replay mode is set, the file size is set to [For mail
(short)] and cannot be changed.
[Noise reduction]
Noise reduction processes sound to make conversations clearer. Sound
quality may vary depending on surrounding noise and tone of the voice.
[Display light time]
Even if set to [Always ON], the backlight illumination time is same as
the Display light time for all screens other than the viewfinder.
[Common replay mode]
Image size is set to QCIF: 176×144, image quality to [FINE], file size to
[For mail (short)] (500 KB), Fix camera shake to [OFF], Switch image/
voice to [Image + voice], and Effect shot to [OFF]. These settings
cannot be changed.
Changing settings for shooting
Some settings are not available depending on the image size or for the
sub camera.
Adjusting brightness
Select from five brightness levels.
1
In the shooting screen, press u.
Using digital zoom
<Zoom>
1
In the still picture/moving picture/Information reader/
Shotdeco shooting screen, press v.
: Alternatively, slide the finger to the left/right on the Optical TOUCH
CRUISER (excluding still picture shooting).
Still picture mode
Current zoom position
The previous step to maximum magnification
Moving picture mode
Current zoom position
Status display
: The area affected by zoom depends on the image size.
<Brightness>
Maximum magnification
Maximum magnification
Remaining time
Continued on next page
221