Docomo Prime SH-06A Instruction Manual page 580

AT command
ATS10=<n> Sets the delay time (seconds) for
automatic disconnection
(1/10 seconds).
[M]
ATS30=<n> Disconnects when no data is sent/
received for at least this amount of
time.
[M]
ATS103=<n> Sets delimiter used when adding
an incoming sub-address to
number dialed.
[M]
ATS104=<n> Sets delimiter used when adding
an outgoing sub-address to
number dialed.
[M]
AT¥S Displays current command and
S register settings.
[M]
AT¥V<n> Selects response code type used
during connection.
[M]
*1 Stored in FOMA terminal's memory using AT&W
commands.
*2 Not stored in FOMA terminal's memory using AT&W
commands. Not reset with AT&F or ATZ commands.
*3 Perform Redial with ATDNo or ATDLo.
Overview
Sets a register, but has no other effect.
n: 1 to 255 (default setting: n=1)
*1
Only valid during 64K data communication. <n>
is set in minutes.
n: 0 to 255 (default setting: n=0)
n=0 sets inactive timer off.
Only valid during 64K data communication.
n=0: *Asterisk
n=1: /Slash (default setting)
n=2: ¥Yen mark or backslash
Only valid during 64K data communication.
n=0: #Pound sign
n=1: %Percent symbol (default setting)
n=2: &Ampersand
*2
―
Only valid when the ATX<n> command
*1 (nP. 30) setting is not n=0.
n=0: Does not use extended result codes
n=1: Uses extended result codes
Parameter/Explanation
(default setting)
*4 If the ATZ command is executed before the AT&W
command is used, terminal settings return to last
written memory, and prior changes are erased.
*5 Settings written into the FOMA terminal's memory
using the AT&W command is stored as non-volatile
data when power is turned off.
31
Execution
example
ATS10=1o
OK
ATS30=3o
OK
ATS103=0o
OK
ATS104=0o
OK
AT¥So
E1 Q0 V1 X4
&C1 &D2 &S0
&E1 ¥V0
S000=000
S002=043
S003=013
S004=010
S005=008
S006=005
S007=060
S008=003
S010=001
S030=000
S103=001
S104=001
OK
AT¥V1o
OK