Running I-Appli Automatically - Docomo Prime SH-06A Instruction Manual

Auto start

Running i-appli automatically

There are three methods to automatically start i-appli.
Auto start using the Set Auto start to [ON] to enable.
i-appliDX setting
Auto start using the Auto start setting pre-installed in software. Set Auto
software function start to [ON] and register software to enable.
Register up to nine.
Auto start using the Set time, date and day of week for i-appli saved in
FOMA terminal the FOMA terminal to set Auto start. Set Auto start
setting to [ON] and set a schedule to use. Register up to
nine.
Set the correct date and time in advance (nP. 56).
Starting automatically
1
In the Custom menu, select [i-appli]/[i-appli
setting]/[Auto start].
2
Select the setting/t.
If Auto start cannot be started, the error is recorded in the Auto start
error history (only when the handset is turned on).
Automatic startup is not available in the following situations.
Handset is turned off
Other functions are activated
Auto start and Alarm (Alarm/Schedule/Reception/Recording) are set
for the same time
Function lock is applied to i-appli/i-Widget
Mail-type i-appli is set to start automatically when 2in1 mode is set
to [B mode]
FOMA card is not inserted
FOMA card inserted is different from the one that was used when the
appli with Auto start was downloaded
Auto start is not available for Widget Appli.
<Auto start>
i-appli is running
Call is in progress
The functions below operate with the following priority when the same
time is set.
Priority (high b low)
Auto power OFF b Auto power ON b Alarm b i-appli
Function
Auto start
Reset settings deletes the auto start error history and disables the
i-appli Auto start settings.
When two Auto start times for the same software are set within 9
minutes of each other, Auto start does not function. Set Auto start time
interval to 10 minutes or more. [Run error] appears in the Auto start
error history.
Setting software startup time with FOMA terminal settings
■
1
In the Custom menu, select [i-appli]/[i-appli
setting]/[Auto start]/[Details set].
2
Select a number.
: To save new: Select a slot with [--------------------]/t.
: To change the setting: Select a number to change/t/[Update].
: To delete the setting: Select a number to delete/t/[Delete].
3
Select software/t.
4
Set.
;
Select [Daily]/enter a time (24-hour format)/t.
;
Select [Select day]/select day of week/t/C/enter a time
(24-hour format)/t.
;
Select [Set date]/enter the date and time (24-hour format)/t.
■ Enabling Auto start setting for supported software
1
Perform the steps 1 to 3 of "Setting software startup
time with FOMA terminal settings"/[Time interval].
: To disable, delete the setting in "Setting software startup time with
FOMA terminal settings".
: This cannot be selected for software without Auto start settings.
287