Turning Power On/Off; Changing Screen Display To English; Making Initial Setting - Docomo Prime SH-06A Instruction Manual

Alert tone does not sound when Manner mode or Public mode (Drive
mode) is set (Alert tone sounds during a call).
Power ON/OFF

Turning power ON/OFF

Turning power ON
1
Press H (for 2+ seconds).
: It may take some time for the wakeup screen to appear.
: The wakeup screen appears followed by the initial settings screen.
Proceed to Initial setting (nP. 55).
: If initial settings have been completed, the
screen shown on the right appears when
power is turned on. This screen is called the
"stand-by display".
Welcome mail
: "Welcome-ドコモ動画#"
(Welcome-docomo-doga#) and "緊急速報
「エリアメール」 のご案内" (Information of Early
Warning "Area Mail") are saved by default.
: To check a welcome mail: In stand-by, press
t/select the stock icon [C] (mail
message)/t.
• For details on the following operations
nP. 146
If initial settings are not yet completed, the setting screen appears every
time the power is turned on.
If the FOMA card is not inserted, [Insert UIM] and a FOMA card error
appear (nP. 31).
When [Enter PIN1 code] appears, enter the PIN1 code (nP. 118).
When a FOMA card is replaced with a new card, the terminal security
code (four to eight digits) must be entered after turning on the terminal.
If a correct terminal security code is entered, stand-by display appears.
When a wrong terminal security code is entered five times, the power is
turned off. However, turning on the power again is possible.
When [A] appears, the handset is outside the service area or in a
place with no signal. Move to a place where the icon disappears.
Turning power OFF
1
Press H (for 2+ seconds).
: It may take some time for the power to be turned off (The end screen
appears on the display until the power is turned off).
Select language

Changing screen display to English

1
In the Custom menu, select
[Bilingual]/[English].
: To switch the display language from English to Japanese: In the
Custom menu, select [Settings]/[General settings]/[Select
language]/[日本語].
If a FOMA card is inserted, settings are saved to the FOMA card as
well. When the setting of the FOMA terminal handset and the setting of
the inserted FOMA card are different, the setting in the FOMA card is
prioritized.
Initial setting

Making initial setting

Stand-by display
The initial settings screen appears automatically when the power
is turned on for the first time. Each setting item can also be set
from Menu (When the initial settings are complete, the stand-by
display appears).
Date and time settings
Key/Touch sound
Set all font size
When items that have not been set remain, the setting screen appears
every time the power is turned on.
Alternatively, select [Settings]/[Initial setting] in the Custom menu to
display the setting screen.
[設定]/[一般設定]/
Change terminal security code
Location request menu
Continued on next page
55