Docomo Prime SH-06A Instruction Manual page 428

Using a service
1
In the Custom menu, select [Settings]/[Other NW
Services]/[Multi number].
2
Select the service.
;
Select [Set multi number]/select a phone number to
[Yes].
• Set a phone number to use.
;
Select [Check setting].
;
Select [Number setting]/[Additional No1]/[Additional
enter a name/t/enter a phone number/t/select a ring
tone/i.
• Register Multi Numbers.
• Enter up to 14 single-byte (7 double-byte) characters for a name,
and 27 digits for a phone number.
■ Submenu operations for phone number setting screen
[Edit]/edit a Multi Number
Editing procedures are the same as when saving.
[Delete]/[Yes]
Calling from selected phone number
<Sel Multi number>
1
In stand-by, enter a phone number/C/[Sel Multi
number].
2
Select a phone number to use/t/s (Phone)/i
(V.phone).
426
2in1
Using 2in1
2in1 is a service that two phone numbers and two mail addresses
can be used on one mobile phone with dedicated mode function
as if two different mobile phones were used.
use/t/
A mode Available operations are calling from your phone number
(Number A), sending/receiving i-mode mail (Address A) and
viewing related information.
No2]/
B mode Available operations are calling from the 2in1 phone number
(Number B), sending/receiving i-mode mail (Address B) and
viewing related information.
Dual mode Available operations are those of both the A and B modes.
Packet transmission is available even in the B mode if i-mode is
subscribed.
For details on using functions in each mode nP. 429
When a call/transmission is made from an external device with 64K data
communication, Number A is used when 2in1 mode is set to [A mode]/
[Dual mode]. Number B is used when 2in1 mode is set to [B mode].
However, if Redial is performed with the AT command when [Dual mode]
is set, Redial is performed with the last dialed number.
Refer to "Mobile Phone User's Guide [2in1]" for details on 2in1.
Starting to use 2in1
1
In the Custom menu, select [Settings]/[NW
Services]/[2in1 setting].
2
Enter the terminal security code/t.
: When the 2in1 has already been used, the 2in1 setting menu screen
appears.
3
Select [Yes].
<2in1 setting>