Docomo Prime SH-06A Instruction Manual page 276

Setting operating conditions for i-appli
<Set software use>
Set the following operating conditions for each software.
Network set Set whether data can be transmitted while
i-appli is running.
i-appli To Set whether to start i-appli with i-appli To.
i-appli call set When i-appli call is received, set whether to
allow to start i-appli.
Icon info set Set whether software should be notified
regarding icons indicating unread mail and
Message R/F, battery level, Manner mode
setting and whether the handset is inside or
outside the service area, while i-appli is running.
To allow ring tone/ Set whether to allow the i-appli to change the
image/icon changes ring tone and screen.
by software
To show When [Allow ring tone/image/icon changes by
confirmation screen software] is set to [Yes], set whether to show the
by all changes confirmation screen when settings are changed.
To access to Set whether to allow the i-appli to access the
phonebook/call phonebook or Redial/Received calls.
records by software
Location usage Set whether to use location information for GPS
setting compatible i-appli.
Some settings are not available depending on the software.
1
In the software list screen, select software/C/[Set
software use].
2
Select a field to set/t.
3
Select the setting/t.
: To set other operating conditions continuously: Repeat steps 2 and
3.
4
Press i.
274
[Network set]
Software may not function properly and information may not be
available in a timely manner if Network set is set to [No]. This may also
prevent some software from starting.
Because images used with i-appli and entered data are sent via the
Internet, some of these information may be viewed by a third party
("Images used with i-appli" include images shot using the camera
function operated with i-appli, images acquired using the Ir
communication function operated with i-appli, and images viewed and
retrieved from Data box operated with i-appli).
[i-appli To]
The software to start is determined by the site, i-mode mail, Message
R/F, screen memo or ToruCa. Download the specified software in
advance.
[i-appli call set]
i-appli call setting may not become valid depending on software.
[Icon info set]
The software requires icon information may not function properly if set
to [No].
If Icon information setting is set to [Yes], the icon status for unread mail/
Message R/F, battery level, the Manner mode, and inside/outside the
service area may be sent via the Internet to the IP (Information
Provider) along with "terminal ID and UIM ID", and this information may
be viewed by a third party.
[Allow access to phone book/call records by software]
Setting this to [No] may prevent operation of some i-appli.