Send Own No./No Caller - Docomo Prime SH-06A Instruction Manual

Dialing with message
1
In stand-by, enter a phone
[Chaku-moji].
: Alternatively, enter a phone number and press m.
: In the phonebook or Redials/Received calls details screen: Press
m.
2
Select a message.
;
Select [Create message]/enter a message/t.
;
Select [Select message]/select a message/t.
;
Select [Sent messages]/select a message/t.
3
Press s (Phone)/i (V.phone).
: If Chaku-moji reaches the recipient, [Transmission completed]
appears and transmission charges are incurred.
The ten most recently sent messages are recorded as Sent messages.
When 2in1 is used, up to ten sent messages of each Number A and
Number B are recorded respectively.
On Redial voice call, Chaku-moji used when a Videophone was dialed
will be automatically sent.
In the following cases, transmission charges are applied.
When the sending result does not appear even if the other party has
received Chaku-moji, due to the signal strength
When a call is shorter than the set ringing time of the Set mute ring
time
<Chaku-moji>
number/C/
When the call recipient is in the following cases, Chaku-moji does not
appear and transmission charges are not incurred even if dialed with
Chaku-moji.
When the recipient's terminal does not support Chaku-moji
When a call is received from numbers rejected by the message
display settings
In addition, when the call recipient is in the following setting or status,
the send results do not appear on the sender side display (Chaku-moji
is not recorded in Received calls on the receiver side).
When the handset is outside the service area or the power is turned off
When the Public mode (Drive mode) is set
When the answering duration for Record message is set to "0
seconds"
For overseas usage, Chaku-moji cannot be sent or received.
Submenu operations for sent message history screen
■
[Delete one]/[Yes]
[Delete all]/enter the terminal security code/t/[Yes]
Send own no./No caller ID
Setting caller ID to send/not to send for
each call
Specifications made when making a call take priority over the method for
setting in advance (nP. 57).
Specifying caller ID to send/not send when
making a call
<Caller ID setting>
1
In stand-by, enter a phone number/C/[Caller ID
setting].
2
Select the setting.
: To notify caller ID: Select [Send own no.].
: To not notify caller ID: Select [No caller ID].
: To follow the Notify caller ID setting of the network service
(nP. 57): Select [As NW setting].
3
Press s (Phone)/i (V.phone).
67