Docomo Prime SH-06A Instruction Manual page 506

: During rewriting, all of the keys are disabled. It is not possible to
cancel rewriting. Also, calls cannot be received while rewriting is
being performed.
: Upon the completion of rewriting, the power is automatically turned
off, and then back on again.
3
When power is turned on, software update starts
automatically.
: During update, all of the keys are disabled. It is not possible to cancel
update. Also, calls cannot be received while update is being
performed.
: Approximately 5 seconds after the completion of updating, the power
is automatically turned off, and then back on again.
4
[Your update is complete] appears/t.
: Software update ends and the stand-by display appears.
: If t is not pressed when the update is completed, the stock icon [6]
(Update complete) appears in the stand-by display. Once the stock
icon [6] (Update complete) is confirmed, it disappears.
■ When server is congested
When [Server is busy] appears, select [Reserve] and
set a date on which updating will be performed
(nP. 504).
Post-update display
■
When the stock icon [6] (Update complete) or [6] (Check update) appears
in stand-by, select the stock icon. If the terminal security code is entered
when software update is incomplete, a message stating so appears. Retry
update.
504
Setting a time at which update will be performed
<Reserve>
Set date and time to update software when downloading takes too much
time or the server is extremely congested.
1
Select [Reserve].
: Schedule selection screen appears.
: The time and date are the same as the server
time.
2
Select the preferred date and time/t/[Yes].
: Alternatively, select the date and time after selecting [Other date/
time] and accessing the server. In the screen for selecting times, the
schedule status appears as [A:Avail] or [C:Limited] for each time
slot. Select a time to reconnect to the server and show schedule
candidates. Select a schedule.
When reserved date and time arrives
■
1
[Ready to update?] appears/t.
: Approximately 5 seconds after [Ready to update?] appears, software
update automatically starts.