Docomo Prime SH-06A Instruction Manual page 113

LED color settings/LED pattern settings
Setting illumination
Set the flashed LED color, the flashing pattern, and whether to
flash, in a call, when receiving a call, when using GPS function,
etc.
Available settings differ depending on the items.
Item
Called LED Phone
Video-phone
Mail LED Mail/Message LED
Mail send/rcv LED
In-call LED
Alarm/Timer LED
IC card LED
Open/close LED
GPS LED Position location
Location notification
Loc provision/accept
Loc provision/notify
A : Settings can be changed.
B : Settings cannot be changed.
1
In the Custom menu, select [Settings]/[Disp/LED/
Power saver]/[LED settings].
2
Select an item/t/[ON].
3
Select [LED color settings]/select the LED
t.
: Select a color with u to check the LED color.
LED LED
Flash
color pattern
B A A
B A A
B A A
A A A
A A A
A A A
A B B
A A A
A A B
A A B
B A B
B A B
color/
4
Select [LED pattern settings]/select the LED
pattern/t.
: Select a pattern with u to check the LED flashing pattern.
When a call is received during data transmission, the LED color is the
set color for the voice called LED.
Called LED and Mail LED are prioritized as follows when they are set
multiply.
Called LED Phonebook called LED b group called LED b regular
called LED
Phonebook mail LED b group mail LED b regular mail
Mail LED
LED
Notice LED
Notifying you of missed call and new
mail with LED
Set the LED to flash for missed calls and new mail.
The LED flashes in [Aqua] for missed calls, in [Leaf] for new mail, and in
[Sunshine] for both missed calls and new mail at approximately 4-second
intervals.
1
In the Custom menu, select [Settings]/[Disp/LED/
Power saver]/[LED settings]/[Notice LED].
2
Select an item/t/[ON].
If no operation is performed for approximately 24 hours after Notice
LED starts flashing, the LED turns off.
Priority (high b low)
111