Receiving Early Warning "Area Mail; Setting Early Warning "Area Mail - Docomo Prime SH-06A Instruction Manual

During software update
While 1Seg is being watched
When battery level is low
While microSD management appli is being activated
Missed Area Mail cannot be received again.
Area Mail is received without i-mode subscription.
Receive Area Mail

Receiving Early Warning "Area Mail"

Area Mail is automatically received.
Save up to 30 Area Mails in Inbox.
1
Receive Area Mail automatically.
2
When Area Mail is received, the dedicated alarm tone
(beep sound) or Area Mail dedicated ring tone sounds
and Called LED flashes red ([v] appears).
: There are two types of Area Mail: For the first type, the message
automatically appears after received, and for the second type, [Area
mail received] appears.
: Press t, c or H, and the screen before reception reappears if
the message automatically appears.
: When [Area mail received] appears, the screen before reception
automatically reappears in approximately 30 seconds.
: Whether to automatically display Area Mail message when received
is set on the distributor side.
For an earthquake early warning, the dedicated alarm tone (beep
sound) and vibration are activated, and the message is automatically
displayed. The volume is set to [Volume 10] and vibrator is set to
[Melody ON], the type of the dedicated alarm tone (beep sound), the
volume and the vibrator cannot be changed.
The tone of the Area Mail dedicated ring tone cannot be changed. The
Beep time follows the Mail ring time setting, the volume follows the Mail
ring volume and the vibrator follows the vibrator setting. However, the
type of vibrator is applied [Melody ON].
During pattern definitions update
During GPS positioning
Called LED color of Area Mail is set to [Sun set] and LED pattern is set
to [Melody ON], and these settings cannot be changed.
When Area Mails saved in the FOMA terminal exceed the maximum
number of saved Area Mail, they are deleted starting from the oldest
read Area Mail. When all Area Mails are unread, they are deleted
starting from the oldest unread Area Mail.
Area Mail setting

Setting Early Warning "Area Mail"

Set whether to receive Area Mail.
1
In stand-by, press m/[Mail setting]/[Area Mail
setting]/[Receive setting].
2
Select the setting/t.
The Area Mail setting is returned to the default setting [Yes] when
Reset mail settings or Reset settings are performed.
Setting receive entry of Area Mail
Save the Area Mail name and MessageID (ID provided by a service
provider) of the information to be received other than emergency
information (earthquake early warning, disaster and evacuation
information). When emergency information (earthquake early warning,
disaster and evacuation information) is received, the receive entry is not
required.
The preset Emergency cannot be edited or deleted.
Give any name to the Area Mail.
Set up to 20 entries (excluding Emergency).
1
In stand-by, press m/[Mail setting]/[Area Mail
setting]/[Other menu]/[Receive entry].
2
Enter the terminal security code/t/i.
: To modify saved contents, select a set receive entry.
: To delete a set receive entry: Select the receive entry/m/[Yes].
<Receive entry>
Continued on next page
163