Docomo Prime SH-06A Instruction Manual page 503

Using software update
Software is updated even when Access point setting of Common
Settings in i-mode setting is set to a custom host.
Recharge battery before updating software.
Software cannot be updated during the following conditions.
While in Self mode
During a call/Outside the service area
Connected to an external device
Omakase Lock is set
During International roaming
Date and time are set incorrectly
Battery level is below the necessary level to update software
Updating (downloading and rewriting) software may take time.
Making/Receiving calls, transmission functions and other functions
cannot be used while software is being updated (Receiving voice calls is
possible during download).
During software update, the handset makes an SSL/TLS connection with
the server (DOCOMO site). Set the SSL/TLS certificate to valid (The
default setting is [Enable] nP. 192).
It is recommended to update software at a location with a strong signal
(three bars for the antenna icon) and you are not moving.
※ If signal status becomes weak or download is interrupted when
downloading software, update software again in a location with good
signal conditions.
If software has already been uploaded, [No update is needed. Please
continue to use as before] appears when software update is checked.
While updating software, received i-mode mail and Message R/F are
held at i-mode center. Received SMS is held at SMS center.
When software is reloaded after update, icons which indicate storage
status of i-mode center (nP. 30) will disappear. In addition, even if
Receive option is set to [ON] and mail is received during software
update, notices may not appear on the display after update is completed.
Mail and messages are held at i-mode center.
When updating software, information about the FOMA terminal (model,
serial number, etc.) is automatically sent to the server (DOCOMO
software update server). Sent information is only used for software
update.
If software update fails, [Rewrite failed] appears and all operations are
not available. In this case, bring the FOMA terminal to a repair center that
DOCOMO specifies.
Updating of software is not available overseas.
During software update, Reception reserve alarm and Recording reserve
alarm are not activated. In addition, watching or recording does not start.
Updating software automatically
The new version of software is automatically downloaded, and the software
is rewritten on the time set in advance.
At the time of purchase, Set auto-update is set to [auto-update], Day is set
to [Default], and Time is set to [03:00].
When the software becomes ready to be rewritten, the stock icon [6]
(Update required) appears to confirm the time when the rewrite starts, the
time to rewrite can be changed, and whether to rewrite now can be selected.
If the time when the rewrite starts arrives with the stock icon [6] (Update
required) displayed, the software is automatically rewritten and the stock
icon [6] (Update required) disappears.
<Set auto-update>
501