When the FOMA terminal placed in the desktop holder is set to the
Cycloid position, operate while holding it so as not to come off
from the desktop holder.
Battery level
Checking battery level
"
Battery level is still sufficient.
#
Battery level is low.
Battery is almost empty. Charge the
$
battery.
Battery is empty (Power will turn off
%
soon).
{
Battery pack is being charged.
Checking battery level with sound and display
1
In the Custom menu, select [Settings]/[General
settings]/[Check status]/[Battery level].
Graphic
Sound
Three beeps
Battery is
Status
sufficiently full.
: Wait approximately 2 seconds and the display disappears.
: The battery level sound is heard at the volume set in Key/
Standby i-motion (nP. 98).
Two beeps
One beep
Battery is
Battery is almost
running low.
empty. Charge
the battery.
If battery runs out
[Battery empty. Unsaved data will be lost. Ending
current operation] appears if battery starts to run out
(Press t to clear the message). After a while, an
alert tone sounds. The warning screen stating that the
battery runs out appears, handset operations are disabled and power
turns off after approximately 60 seconds.
During a voice/Videophone call, the alert tone sounds and [Battery
empty. Unsaved data will be lost. Ending current operation]
appears. The call is disconnected after approximately 20 seconds.
At the same time, the screen above appears and after
approximately 60 seconds, the power turns off.
Alert tone does not sound when Manner mode or Public mode
(Drive mode) is set (Alert tone sounds during a call).
Power ON/OFF
Turning power ON/OFF
Turning power ON
Press H (for 2+ seconds).
1
: It may take some time for the wakeup
screen to appear.
: The wakeup screen appears followed by the
initial settings screen. Proceed to Initial
setting (nP. 48).
Initial settings
screen
Continued on next page
47
Need help?
Do you have a question about the SH-01A and is the answer not in the manual?
Questions and answers