Command Syntax; Displaying And Modifying System Parameter Default Settings - Foundry Networks FESX Manual

Foundry Configuration Guide for the FESX, FSX, and FWSX
Feature" in the Foundry Security Guide.

Command Syntax

To enable address locking for port 2 and place a limit of 15 entries, enter a command such as the following:
FESX424 Switch(config)# lock e 2 addr 15
Syntax: lock-address ethernet [<slotnum>/]<portnum> [addr-count <num>]
The <slotnum> parameter is required on chassis devices.
The <num> parameter is a value from 1 – 2048.

Displaying and Modifying System Parameter Default Settings

Foundry devices have default table sizes for the system parameters shown in the following display outputs. The
table sizes determine the maximum number of entries the tables can hold. You can adjust individual table sizes to
accommodate your configuration needs.
The tables you can configure, as well the defaults and valid ranges for each table, differ depending on the Foundry
device you are configuring. To display the adjustable tables on your Foundry device, use the show default values
command. The following shows example outputs on FESX, FSX, and FWSX devices.
NOTE: If you increase the number of configurable subnet addresses on each port, you might also need to
increase the total number of subnets that you can configure on the device.
NOTE: Changing the table size for a parameter reconfigures the device's memory. Whenever you reconfigure
the memory on a Foundry device, you must save the change to the startup-config file, then reload the software to
place the change into effect.
4 - 8 © Foundry Networks, Inc. December 2005