Dtc P0500 (Dtc No.16) Vehicle Speed Sensor (Vss) Malfunction - Suzuki Jimny Service Manual

Jimny suzuki

Hide thumbs Also See for Jimny:

Table of Contents

6-94 ENGINE GENERAL INFORMATION AND DIAGNOSIS

DTC P0500 (DTC No.16) Vehicle Speed Sensor (VSS) Malfunction

CIRCUIT DESCRIPTION

2. Combination meter

For TYPE A and TYPE B, refer to the NOTE in "ECM Terminal Voltage Values Table" for applicable

DTC DETECTING CONDITION

• VSS signal not inputted while vehicle running in "D"

range or during fuel cut at deceleration.

✱ ✱ ✱ ✱ 2 driving cycle detection logic, continuous monitoring

DTC CONFIRMATION PROCEDURE

• When performing a road test, select a place where there is no traffic or possibility of a traffic acci-

dent and be very careful during testing to avoid occurrence of an accident.

• Road test should be carried out with 2 persons, a driver and a tester.

1) Clear DTC and warm up engine to normal operating temperature.

2) Increase vehicle speed to 50 mph, 80 km/h in 3rd gear or "2" range while observing vehicle speed displayed

on scan tool.

3) Release accelerator pedal and with engine brake applied, keep vehicle coasting (fuel cut condition) for 4

sec. or more.

4) Check pending DTC and DTC.

3. VSS connector

[A] : Case of TYPE A is shown (See NOTE)

[B] : Case of TYPE B is shown (See NOTE)

POSSIBLE CAUSE

• "B/Or" circuit open

• "Y" or "Bl/B" circuit open or short

• VSS malfunction

• ECM malfunction

• Speedometer malfunction

Table of Contents