G Sensor - Suzuki Jimny Service Manual

G Sensor

REMOVAL
1) Turn ignition switch "OFF" and disconnect battery negative
cable.
2) Remove rear center console box.
3) Disconnect connector from G sensor (2).
4) Remove G sensor (2) from floor.
CAUTION:
Sensor must not be dropped or shocked. It will affect its
original performance.
1. Parking brake lever assembly
3. Bolt
INSPECTION
Connect positive cable of 12 volt battery to "A" terminal of sensor
and ground cable to "C" terminal. Then using voltmeter, check
voltage between "B" terminal and "C" terminal.
If measured voltage is not as specified, replace sensor with
bracket.
G sensor specification
When placed horizontally : 2 – 3V
When placed upright with arrow upward : 3 – 4V
When placed upright with arrow downward : 1 – 2V
[A] : Horizontal
[B] : Upright with arrow upward
[C] : Upright with arrow downward
INSTALLATION
1) Connect connector to sensor securely.
2) Install sensor onto floor so that arrow mark directs vehicle
forward.
Tightening torque
G sensor bolts
(a) : 23 N·m (2.3 Kg-m, 17.0 lb-ft)
3) Install rear console box.
ANTILOCK BRAKE SYSTEM (ABS) 5E-39