Maintenance Service; Engine; Drive Belt - Suzuki Jimny Service Manual

Jimny suzuki

Hide thumbs Also See for Jimny:

Table of Contents

Maintenance Service

All inspection and replacement are to be performed with

ENGINE NOT RUNNING.

WATER PUMP AND GENERATOR DRIVE BELT INSPEC-

1) Disconnect negative cable at battery.

2) Inspect belt for cracks, cuts, deformation, wear and cleanli-

ness. If any defect exists, replace.

Check belt for tension.

Water pump and generator belt tension

"a": 4.5 – 5.5 mm (0.18 – 0.22 in.) deflection under 100 N

(10 kg, 22 lb) pressure

When replacing belt with a new one, adjust belt tension

to 3 – 4 mm (0.12 – 0.16 in.).

3) If belt is too tight or too loose, adjust it to specification by

adjusting alternator position.

4) Tighten alternator adjusting bolts and pivot bolt.

5) Connect negative cable to battery.

Replace belt. Refer to "Water Pump Belt and Cooling Fan" in Sec-

tion 6B for replacement procedure of pump belt.

POWER STEERING PUMP AND/OR A/C COMPRESSOR

DRIVE BELTS INSPECTION (IF EQUIPPED)

1) Disconnect negative cable at battery.

2) Inspect belt for cracks, cuts, deformation, wear and cleanli-

ness. If any defect exists, replace.

MAINTENANCE AND LUBRICATION 0B-5

Table of Contents