Suzuki Jimny Service Manual page 392

TERMINAL
NO.
26 Manifold absolute pressure sensor
27 A/C evaporator temp. sensor
E19 EGR valve (stepper motor coil 4, if
28
equipped)
EGR valve (stepper motor coil 2, if
29
equipped)
30
31 Fuel injector NO.3
For TYPE B (See NOTE)
NOTE:
See NOTE in "ECM TERMINAL VOLTAGE VALUES TABLE" for applicable model.
TERMINAL
NO.
1 Ground
2 Ground
3 Ground
4 EVAP canister purge valve
Power steering pressure switch
5
(if equipped)
6 Idle air control valve
7 Heater of HO2S-1
8 Fuel injector NO.4
9 Fuel injector NO.1
10 Sensor ground
E19
11 Camshaft position sensor
12
Heater oxygen sensor-1
13
CO adjusting resistor (w/o HO2S)
14 Engine coolant temp. sensor
15 Intake air temp. sensor
16 Throttle opening signal
EGR valve (stepper motor coil 3, if
17
equipped)
CIRCUIT
–
CIRCUIT
–
ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-35
NORMAL
VOLTAGE
Ignition switch ON
3.3 – 4.0 V Barometric pressure : 100 kPa
(760 mmHg)
Ignition switch ON A/C evaporation temp.
2.0 – 2.3 V
sensor at 25 °C (77 °F)
Ignition switch ON position leaving engine
10 – 14 V
OFF
Ignition switch ON position leaving engine
10 – 14 V
OFF
–
10 – 14 V Ignition switch ON
NORMAL
VOLTAGE
–
–
–
10 – 14 V Ignition switch ON
While engine running at idle speed, turn
0 – 1.3 V steering wheel to right or left as far as it
stops
10 – 14 V Ignition switch ON
At specified idle speed after engine
0 – 13 V
warmed up
10 – 14 V Ignition switch ON
10 – 14 V Ignition switch ON
10 – 14 V Ignition switch ON
–
0 – 0.8 V and
Ignition switch ON
4 – 6 V
–
Refer to DTC P0130 diag. flow table
0 – 5 V Ignition switch ON position
Ignition switch ON
0.55 - 0.95 V
Engine coolant temp. : 80 °C (176 °F)
Ignition switch ON
2.0 – 2.7 V
Intake air temp. : 20 °C (68 °F)
Ignition switch ON position and throttle
0.2 – 1.0 V
valve at idle position
Ignition switch ON position and throttle
2.8 – 4.8 V
valve fully open
Ignition switch ON position leaving engine
10 – 14 V
OFF
CONDITION
–
CONDITION
–
–
–
–
–