Centering Contact Coil (For Vehicle With Air Bag System) - Suzuki Jimny Service Manual

3C-8 STEERING WHEEL AND COLUMN
3) Tighten steering shaft nut to specified torque.
Tightening torque
Steering shaft nut (a) : 33 N·m (3.3 kg-m, 23.5 lb-ft)
NOTE:
After installing the steering wheel, turn the steering
wheel about 1 full rotation so that the cancel cam pin fits
into the pin hole in the steering wheel and then check the
turn signal lever for proper function.
4) Install steering wheel pad (for vehicle without air bag system)
or driver air bag (inflator) module (for vehicle with air bag
system) as follows.
• For vehicle without air bag system
– For TYPE A
a) Connect horn connector.
b) Install steering wheel pad.
– For TYPE B
a) To install the pad, hook (1) the upper part of the pad to the
pawl of the steering wheel and push in the lower part of the
pad until it fits to the set spring securely.
• For vehicle with air bag system
a) Install driver air bag (inflator) module to steering wheel.
Refer to "Driver Air Bag (Inflator) Module" in this section.
Centering contact coil (for vehicle with air bag sys-
tem)
1) Check that vehicle's wheels (front tires) are set at straight-
ahead position.
2) Check that ignition switch is at "LOCK" position.
3) Turn contact coil counterclockwise slowly with a light force till
contact coil will not turn any further.
NOTE:
Contact coil can turn about 5 turns at maximum, that is, if
it is at the center position, can turn about two and a half
turns both clockwise and counterclockwise.