POWER STEERING (P/S) SYSTEM (If equipped) 3B1-19
8) Disconnect high pressure hose (2) and return hose (3) from
gear box (1).
NOTE:
Plug up the section where hose disconnection.
9) Remove gear box assy from vehicle.
CAUTION:
Never turn gear box input shaft. Otherwise, air goes into
gear box, which needs air bleeding for gear box.
NOTE:
• Don't disassemble P/S gear box.
• For adjustment of worm shaft starting torque, refer to
item "Adjustment of Worm Shaft Starting Torque" in
Section 3B.
INSTALLATION
Reverse removal procedure to install P/S gear box noting the fol-
lowing points.
• Tightening torque specification.
Tightening torque
Power steering gear box mounting bolt and nuts
(a) : 80 N·m (8.0 kg-m, 58.0 lb-ft)
Gear box high pressure union bolt
(b) : 35 N·m (3.5 kg-m, 25.5 lb-ft)
• Before servicing, set steering wheel and wheel / tire at
straight position.
1. Steering gear box
2. Bolt (long)
3. Bolt (short)
4. High pressure hose
5. Return hose