Bump Stopper And Spring Upper Seat; Wheel Hub / Bearing / Oil Seal - Suzuki Jimny Service Manual

5) Install wheel and tighten wheel nuts to specified torque.
Tightening torque
Wheel nuts
(a) : 95 N·m (9.5 kg-m, 69.0 lb-ft)
6) Lower hoist.
7) Confirm front end (wheel) alignment, referring to "Prelimi-
nary Checks Prior to Adjusting Front Alignment" in Section
3A.

Bump Stopper and Spring Upper Seat

REMOVAL
1) Remove coil spring, refer to "Coil Spring" in this section.
2) Remove bump stopper and spring upper seat.
INSTALLATION
1) Install bump stopper (1) and spring upper seat (2).
NOTE:
Before installing bump stopper (1), apply soap water on
it.
2) Install coil spring, refer to "Coil Spring" in this section.

Wheel Hub / Bearing / Oil Seal

REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove brake caliper carrier bolts and suspend caliper (1).
CAUTION:
During removal, be careful not to damage brake flexible
hose and not to depress brake pedal.
3) Remove ABS wheel sensor (if equipped with ABS).
FRONT SUSPENSION 3D-21