Dtc Check (Using Suzuki Scan Tool); Diagnostic Trouble Code (Dtc) Clearance - Suzuki Jimny Service Manual

5E-10 ANTILOCK BRAKE SYSTEM (ABS)

DTC Check (Using SUZUKI Scan Tool)

1) Connect SUZUKI scan tool to data link connector after set-
ting cartridge for ABS to it.
Special tool
(A) : SUZUKI scan tool
2) Turn ignition switch ON.
3) Read DTC according to instructions displayed on SUZUKI
scan tool and print it or write it down. Refer to SUZUKI scan
tool operator's manual for further details.
4) After completing the check, turn ignition switch off and dis-
connect SUZUKI scan tool from DLC.

Diagnostic Trouble Code (DTC) Clearance

WARNING:
When preforming a driving test, select a safe place where
there is neither any traffic nor any traffic accident possi-
bility and be very careful during testing to avoid occur-
rence of an accident.
After repair or replace malfunction part(s), clear all DTC's by pre-
forming the following procedure.
1) Turn ignition switch OFF.
2) Using service wire (4), connect diag. switch terminal (3) of
monitor connector (1) to ground terminal (2).
3) With connection described in above step 2) maintained, turn
ignition switch ON.
4) Repeat ON/OFF operation of service wire (4) at ground ter-
minal (2) at least 5 times within 10 seconds.
NOTE:
Service wire ON time must be for 0.1 second and more.
5) Turn ignition switch OFF and disconnect service wire (4)
from monitor connector (1).
6) Perform "DRIVING TEST" (Step 2 of "ABS Diagnostic Flow
Table") and "DTC CHECK" and confirm that normal DTC
(DTC 12) is displayed.
NOTE:
It is also possible to clear DTC by using SUZUKI scan
tool. Refer to Cartridge Manual for procedure to clear
DTC.