Suzuki Jimny Service Manual page 571

6A1-90 ENGINE MECHANICAL (M13 ENGINE)
INSTALLATION
NOTE:
• All parts to be installed must be perfectly clean.
• Be sure to oil crankshaft journals, journal bearings,
thrust bearings, crankpins, connecting rod bearings,
pistons, piston rings and cylinder bores.
• Journal bearings, bearings caps, connecting rods, rod
bearings, rod bearing caps, pistons and piston rings
are in combination sets. Do not disturb such combina-
tion and make sure that each part goes back to where
it came from, when installing.
1) Install sensor plate (1) to crankshaft (2) and tighten bolts to
specified torque.
NOTE:
When installing sensor plate, align spring pin (3) on
crankshaft and hole of sensor plate.
Tightening torque
Sensor plate bolts (a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
2) Install main bearings to cylinder block.
Upper half of bearing (1) has an oil groove (2).
Install it to cylinder block (3), and the other half without oil
groove to bearing cap.
Make sure that two halves are painted in the same color.
3) Install thrust bearings (1) to cylinder block between No.2 and
No.3 cylinders. Face oil groove (2) sides to crank webs.
4) Confirm that dowel pins(3) are installed to intake side of
each journal.