Suzuki Jimny Service Manual page 527

6A1-46 ENGINE MECHANICAL (M13 ENGINE)
INSTALLATION
1) Install tappets and shims to cylinder head.
Apply engine oil around tappet and then install it to cylinder
head.
NOTE:
When installing shim, make sure to direct shim No. side
toward tappet.
2) Install camshafts (1).
Apply engine oil to sliding surface of each camshaft and
camshaft journal then install them as shown in figure.
NOTE:
Before installing camshafts, turn crankshaft until key
position faces upward. Refer to "Timing Chain and Chain
Tensioner".
3) Install camshaft housing pins (1) as shown in figure.
4) Check position of camshaft housings.
Embossed marks are provided on each camshaft housing,
indicating position and direction for installation. Install hous-
ings as indicated by these marks.
A. I : Intake side or E : Exhaust side
B. Position from timing chain side
C. Pointing to timing chain side