Suzuki Jimny Service Manual page 513

6A1-32 ENGINE MECHANICAL (M13 ENGINE)
3) Install crankshaft pulley (1). Tighten bolt (2) to specified
torque.
To lock crankshaft pulley, use special tool with it as shown in
figure.
Special tool
(A) : 09917-68221
Tightening torque
Crankshaft pulley bolt (a) : 150 N·m (15.0 kg-m, 108.5 lb-ft)
4) Install P/S pump bracket (1), P/S pump (2) and A/C com-
pressor and/or P/S pump belt tension pulley (3) (if equipped)
referring to "Power Steering Pump" in Section 3B1.
5) Install cylinder head cover referring to "Cylinder Head Cover"
in this section.
6) Install oil pan referring to "Oil Pan and Oil Pump Strainer" in
this section.
7) Install radiator with cooling fan and connect A/T fluid hoses
(vehicle with A/T), radiator inlet and outlet hoses referring to
"Water Pump Belt and Cooling Fan" and "Radiator" in Sec-
tion 6B.
8) Adjust generator belt tension referring to "Water Pump Belt
Tension" in Section 6B for adjusting procedure.
9) Adjust A/C compressor and/or P/S pump belt tension (if
equipped) referring to "Compressor Drive Belt" in Section 1B
or "Power Steering Belt" in Section 3B1 for adjusting proce-
dure.
10) Refill cooling system with coolant, engine with engine oil and
A/T with specified A/T fluid (vehicle with A/T).
11) Verify that there is no coolant leakage, oil leakage and A/T
fluid leakage (vehicle with A/T) at each connection.