Suzuki Jimny Service Manual page 193

3D-20 FRONT SUSPENSION
4) Support front axle housing by using floor jack.
NOTE:
When supporting axle housing, it should be in non-load
condition.
5) Remove shock absorber lower mounting bolt (1).
6) Lower front axle housing (2) gradually as far down as where
coil spring (1) can be removed.
7) Remove coil spring (1).
INSTALLATION
Install removed parts in reverse order of removal procedures, not-
ing the followings.
1) Install coil spring (3).
NOTE:
• Make sure that coil spring direction as shown.
• When seating coil spring, mate spring end with
stepped part (4) of lower spring seat (2).
1. Front axle housing
U : Upper side
A : Small
B : Large
2) Install absorber lower mounting bolt, refer to "Front Shock
Absorber" in this section.
3) Install caliper assembly and tighten caliper bolts to specified
torque.
Tightening torque
Brake caliper carrier bolts
(a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
4) Connect stabilizer ball joint to axle housing and tighten nut
referring to "Stabilizer Bar" in this section for tightening
torque specification.