Suzuki Jimny Service Manual page 296

7) Using special tools, draw out rear axle shaft with brake back
plate.
Special tool
(A) : 09943-35511
(B) : 09942-15510
8) Remove wheel bearing retainer and wheel sensor ring (if
equipped with ABS), refer to "Rear Axle Shaft and Wheel
Bearing" in Section 3E.
9) Remove brake back plate from axle shaft.
INSTALLATION
1) Install wheel cylinder, and tighten wheel cylinder bolts to
specified torque. Refer to "Wheel Cylinder" in this section.
2) Install brake back plate (2) to axle shaft (1).
3) For installation procedure here after perform "Rear Axle
Shaft and Wheel Bearing" in Section 3E.
3. Wheel bearing
4. Retainer ring
BRAKES 5-35