Suzuki Jimny Service Manual page 59

1A-6 HEATER AND VENTILATION
4) Disconnect blower fan switch coupler and A/C switch coupler
(if equipped)
5) Disconnect each heater control cables.
6) Remove heater control lever assembly (1).
7) Remove blower fan switch screw (3).
8) Remove blower fan switch (2) as shown figure.
1. Heater control lever assembly
INSTALLATION
1) Install in reverse order of removal procedure, adjustment the
following items.
• Move control lever fully in arrow direction
• Push heater lever and air inlet box lever fully in arrow direc-
tion and fix cable with clamp in position as shown figure.
NOTE:
After installing control cables, be sure that control levers
move smoothly and stop at proper position.
1. Heater unit
2. Air inlet box
3. Mode control cable
4. Temperature control cable
5. Fresh air control cable
2) If equipped with air bag, enable air bag system. Refer to
"Enabling Air Bag System" in Section 10B.