Malfunction Indicator Lamp (Mil) Check; Diagnostic Trouble Code (Dtc) Check - Suzuki Jimny Service Manual

6-14 ENGINE GENERAL INFORMATION AND DIAGNOSIS

Malfunction indicator lamp (MIL) check

1) Turn ON ignition switch (but the engine at stop) and check
that MIL lights.
If MIL does not light up (or MIL dims), go to "Diagnostic Flow
Table A-1" for troubleshooting.
If MIL flushes, go to "Diagnostic Flow Table A-3" for trouble
shooting (vehicle without immobilizer indicator lamp).
2) Start engine and check that MIL turns OFF.
If MIL remains ON and no DTC is stored in ECM, go to
"Diagnostic Flow Table A-2" for troubleshooting.

Diagnostic trouble code (DTC) check

[Using SUZUKI Scan Tool]
1) Prepare SUZUKI scan tool.
2) With ignition switch OFF, connect it to data link connector
(DLC) (1) located on underside of instrument panel at
driver's seat side.
Special tool
(A) : SUZUKI scan tool
3) Turn ignition switch ON and confirm that MIL lights.
4) Read DTC, pending DTC and freeze frame data according to
instructions displayed on scan tool and print it or write it
down.
Refer to scan tool operator's manual for further details.
If communication between scan tool and ECM is not possi-
ble, check if scan tool is communicable by connecting it to
ECM in another vehicle. If communication is possible in this
case, scan tool is in good condition. Then check data link
connector and serial data line (circuit) in the vehicle with
which communication was not possible.
5) After completing the check, turn ignition switch off and dis-
connect scan tool from data link connector.
[Without Using SUZUKI Scan Tool] (Vehicle Without
Immobilizer Indicator Lamp)
1) Check malfunction indicator lamp referring to "Malfunction
Indicator Lamp Check" in this section.
2) With the ignition switch OFF position, connect diagnosis
switch terminal (3) and ground terminal (2) in monitor con-
nector (1) with service wire (4).
3) With the ignition switch ON position and leaving engine OFF,
read DTC from flashing pattern of malfunction indicator
lamp. Refer to "Diagnostic Trouble Code Table".
If lamp does not flash or remains ON or OFF, go to "Diag-
nostic Flow Table A-4".