Dtc P0133 Heated Oxygen Sensor (Ho2S) Circuit Slow Response (Sensor-1) - Suzuki Jimny Service Manual

DTC P0133 Heated Oxygen Sensor (HO2S) Circuit Slow Response (Sensor-1)

WIRING DIAGRAM
Refer to DTC P0130 section.
CIRCUIT DESCRIPTION
DTC DETECTING CONDITION
• When running at specified idle speed after engine warmed up and
running at specified vehicle speed, response time (time to change
from lean to rich or from rich to lean) of HO2S-1 output voltage is
about 1 sec. at minimum or average time of 1 cycle is 5 sec. at
minimum. See. Fig. 1
✱ ✱ ✱ ✱ 2 driving cycle detection logic, Monitoring once / 1 driving.
Fig. 1
DTC CONFIRMATION PROCEDURE
Refer to DTC P0130 section.
INSPECTION
Step
1 Was "Engine Diag. Flow Table" performed?
2 Is there DTC(s) other than HO2S-1 (DTC
P0133)?
Action
ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-61
POSSIBLE CAUSE
• Heated oxygen sensor-1 malfunction
Yes
Go to Step 2.
Go to applicable DTC
Diag. Flow Table.
No
Go to "Engine Diag. Flow
Table".
Replace HO2S-1.