Fuel Pump Assembly - Suzuki Jimny Service Manual

INSTALLATION
1) Install fuel pump (1) assembly to fuel tank. Refer to "Fuel
Pump Assembly" in this section. Install protector to fuel tank.
2) Install inlet valve to fuel tank.
If deformed or damaged in any other way, replace with a new
one.
3) Connect fuel filler and breather hoses to fuel tank and vapor
hose to fuel pump assembly. Clamp them securely.
4) Lift up fuel tank on jack.
Connect fuel feed hose (4) and return hose (3) to pipes as
shown in figure and clamp them securely.
CAUTION:
When connecting joint, clean outside surfaces of pipe
where joint is to be inserted, push joint into pipe till joint
lock clicks and check to ensure that pipes are connected
securely, or fuel leak may occur.
2. Quick joint
5) Install fuel tank to vehicle and connect wire harness coupler.
6) Connect fuel filler hose and breather hose to fuel filler neck.
Connect fuel vapor hose to pipe. Clamp them securely.
7) Install fuel filler hose protector.

Fuel Pump Assembly

WARNING:
Before starting the following procedure, be sure to
observe "Precaution on Fuel System Service" in Section
6.
REMOVAL
1) Remove fuel tank from vehicle. Refer to "Fuel Tank" in this
section.
2) Disconnect wire harness coupler and fuel vapor hose from
fuel pump assembly.
3) Remove fuel pump assembly from fuel tank by removing
bolts.
ENGINE FUEL 6C-7