Suzuki Jimny Service Manual page 234

INSTALLATION
Install removed parts in reverse order of removal procedure, not-
ing the following.
1) Aligning serrations between new stud bolt(s) (1) and flange,
install new stud bolt(s) (1) by tightening nut (2) as shown.
3. Washer
4. Flange of axle shaft
2) Press-fit wheel bearing (1) and retainer ring (2) as shown.
NOTE:
• Use care not to cause any damage to outside of
retainer ring (2).
• Refer to figure so that wheel bearing (1) is installed in
proper direction.
3) For vehicle with ABS, press-fit new sensor rotor as shown.
NOTE:
Use care not to cause any damage to outside of retainer
ring (2).
[A]: Vehicle without ABS
[B]: Vehicle with ABS
4) Inspect axle shaft length.
Rear axle shaft length
"a" : 775.5 mm (30.5 in.) (left side),
559.5 mm (22.0 in.) (right side)
5) Apply grease to axle shaft oil seal lip (1) as shown.
"A" : Grease 99000-25010
6) Apply sealant to mating surface of axle housing (2) with
brake back plate.
NOTE:
Make sure to remove old sealant before applying it anew.
"B" : Sealant 99000-31110
REAR SUSPENSION 3E-15