Heater Blower Fan Switch; Heater Unit/Boost Ventilation - Suzuki Jimny Service Manual

Heater Blower Fan Switch

INSPECTION
Check blower fan switch for each terminal-to-terminal continuity.
For the detail refer to "Wiring Circuit" earlier in this section.
TERMINAL
B
POSITION
OFF
Lo
M
Hi

Heater Unit/Boost Ventilation

REMOVAL
1) Disconnect negative (–) cable at battery.
2) If equipped with air bag system disable air bag system.
Refer to "Disabling Air Bag System" in Section 10B.
3) Drain engine coolant and disconnect water hoses (1) from
heater unit.
4) Remove instrument panel.
5) Remove bolts, nuts and screws as shown figure.
6) Remove heater unit (1).
INSTALLATION
Install heater unit by reversing removal procedure, noting the fol-
lowing items.
• When installing each part, be careful not to catch any cable
or wiring harness.
• Adjust control cable (refer to heater control lever assembly in
this section).
• Fill engine coolant to radiator.
• If equipped with air bag system, enable air bag system,
Refer to "Enabling Air Bag System" in Section 10B.
HEATER AND VENTILATION 1A-7
E I L M H